Is there a way to cut a hole in a T-Splines volume without converting it to a surface or mesh? Ideally I'd like to cut a hole in it but then keep it editable as a T-Splines object for future use.
Thanks,
Nick
Is there a way to cut a hole in a T-Splines volume without converting it to a surface or mesh? Ideally I'd like to cut a hole in it but then keep it editable as a T-Splines object for future use.
Thanks,
Nick
I have just discovered the answer to my question. It turned out to be a quite Simple task of just turning off some of the faces when i converted the cage to a T-spline volume. The ones turned off were left as gaps.
Nick
You must log in to post.